| Channels |
| |
7 channels |
| Input Impedance |
| |
28K ohms |
| Bandwidth -3dB |
| |
3Hz to 50KHz |
| Frequency Response @ 1W 8ohm |
| |
Flat +0, -0.1dB from 20Hz to
20KHz |
| Total Harmonic Distortion (THD)
@ full power |
| |
0.03% or less |
| IHF I.M. Distortion |
| |
0.01% or less |
| SMPTE I.M. Distortion |
| |
0.03% or less |
| Dynamic Headroom |
| |
2dB or more |
| Signal/Noise Ratio (S/N) "A"
Weighted |
| |
>110dB |
| Gain |
| |
28dB |
| Damping Factor |
| |
>1000 |
| Channel Separation over full
bandwidth |
| |
>100dB |
| Environmental Temperature Range |
| |
41-104°F (5-40°C) |
| Environmental Humidity |
| |
10% to 90% RH (non-condensing) |
| Power Requirements |
| |
Input |
120VAC +/-10%, 60Hz, 2400W |
| |
Cresnet Power |
24VDC @ 0.125A, 3W |
| Output Power |
| |
8 ohm load |
200W/channel. All channels driven,
20Hz to 20KHz, at rated THD |
| |
4 ohm load |
300W/channel |
| Rear Indicators |
| |
PWR |
Green LED is illuminated when
24VDC via the Cresnet connector is supplied to the CNAMPX-7x200. |
| |
NET |
Yellow LED indicates that the
SIMPL program currently loaded in the control system has a network
device defined at the same NET ID code as the CNAMPX-7x200.
LED flashes when communications with the Cresent system and
the CNAMPX-7x200 is occurring. |
| |
OVERRIDE Button & Indicator |
OVERRIDE button is used to activate
AC power and activate all room outputs. Buttons functions only
when 24VDC is applied to the NET connector. Red LED illuminates
when the OVERRIDE is activated. |
| Rear Ports |
| |
NET |
The 4-pin network connector
is used to connect the CNAMPX-7x200 to the Cresnet system. |
| |
Power Connectors and Fuse Compartment |
The power connector provides
AC operating power to the CNAMPX-7x200 via the supplied power
cord. The fuse electrically protects the internal circuitry
from power overloads and is located (a spare fuse is included)
within the compartment above the power connector. |
| |
AUDIO INPUTS |
7 single-ended line level inputs
utilize gold-plated RCA jacks |
| |
SPEAKER OUTPUTS |
The 7 speaker output terminals
are multi-way binding post type. Each post is gold-plated and
accepts bare wire, banana plugs, or spade lugs. |
| Dimensions |
| |
7.70" / 19.56 cm (H)x
19.00" / 48.26 cm (W)x
18.88" / 47.95 cm (D) |
| Weight |
| |
94.4lbs (42.48 kg) |
| Model Options |
| The CNAMPXI-7X200 (International
Version) has all the features of the CNAMPX-7X200, with the
following exceptions: |
| |
Input Power Requirements |
230VAC +/-10%, 50Hz, 2400W |
| |
Room output ports do not accept
banana plugs |
